| Slotted strut nut tool | ||||
 |
Slotted strut nut tool - Removes the slotted nut inside the strut bearing on all Golf2 & Jetta2 models as well as 4 cyl Golf3 and Jetta3 models thru mid '96. Required to remove upper strut bearing/mount. | Not for VR6 models or 4 cyl models w/ VR6 strut bearings | $16.54 | |
| Upper strut nut socket, 21/22mm | ||||
 |
Strut nut socket - Double ended tool, 22mm end fits most top nuts on VW/Audi struts, while 21mm end fits inner nut on VW VR6 and all Mk4 chassis VW models. Handle on outside allows you to turn this tool while the large hole in the top allows you to reach through with an allen wrench to hold the strut shaft from turning. Also accepts a 1/2 inch drive torque wrench or breaker bar. | For all struts retained by 21mm and/or 22mm nuts | $42.00 | |
| Strut spreader bit | ||||
 |
On VW Mk4 cars the bottom of the front suspension strut is clamped into the steering knuckle/wheel bearing housing. This tool spreads the clamp, allowing easy removal of the strut. | Hex base fits into your 13 mm or 1/2 box wrench or socket. | $15.00 | |
| 12 point triple square bit, 14mm size. Impact rated, 1/2 inch drive | ||||
 |
12 point triple-square bit - 14mm size | Required for many front suspension bolts on Mk5 Jetta and new Rabbit models. | $14.50 | |
Facebook© 2012 GermanAutoParts.com